CT Connection for iNVT On Grid Inverter, Single Phase

Last updated: 8 Oct 2026  |  732 Views  | 

CT Connection for iNVT On Grid Inverter, Single Phase

What is a CT or Current Transformer in an on-grid solar system?
A CT, or Current Transformer, is a sensor used to measure electrical current in the main power line. In an iNVT On Grid solar system, it sends household power usage data back to the inverter so the inverter can control its output more accurately.

What does the CT anti-backflow system do?
The CT anti-backflow system measures how much electricity the house is using and sends that information to the inverter. The inverter then adjusts solar production to help reduce or prevent excess power from flowing back to the utility grid.

Which wire should the CT clamp be installed on?
The CT clamp should be installed on the L or Line wire of the main power cable from the utility meter. It should be placed before the power is distributed to the loads inside the house.

Where should the CT sensor be installed in the home electrical system?
The CT sensor should be installed on the main Line wire after the utility meter and before the consumer unit or load panel. This position allows the inverter to read the total household power consumption correctly.

Does the arrow direction on the CT clamp matter?
Yes. The arrow direction on the CT clamp is important because it affects current reading accuracy. The CT must be installed according to the direction shown in the inverter manual or wiring diagram.

Where does the CT signal cable connect on the iNVT inverter?
The CT signal cable connects to the COM port of the iNVT inverter. This connection allows the inverter to receive current measurement data from the CT sensor.

What inverter setting is required after installing the CT?
After installing the CT, open the inverter settings and enable the Export Limitation or anti-backflow function. Then select the correct meter or CT type according to the installed device.

Why must the AC and DC breakers be turned off before CT installation?
The AC and DC breakers must be turned off for safety before installation. This reduces the risk of electric shock, short circuit, equipment damage, or incorrect wiring during work on the solar and electrical system.

What happens if the CT is installed in the wrong direction?
If the CT is installed in the wrong direction, the inverter may read the current incorrectly. This can make Export Limitation or anti-backflow control inaccurate. Always check the arrow direction and the wiring diagram before operation.

What is the Wi-Fi Dongle used for in an iNVT On Grid system?
The Wi-Fi Dongle connects the inverter to the internet. It allows users to monitor system status, solar production, and inverter operation through a mobile application.

What type of inverter does this CT connection apply to?
This CT connection guide applies to an iNVT On Grid single-phase inverter system that uses a CT sensor and the Export Limitation function for anti-backflow control.

Should homeowners install the CT sensor by themselves?
CT installation should be done by a qualified electrician or solar technician. The work involves the main power line, AC and DC breakers, inverter communication wiring, and inverter settings. Incorrect installation can cause inaccurate readings or unsafe operation.




Powered by MakeWebEasy.com
This website uses cookies for best user experience, to find out more you can go to our Privacy Policy  and  Cookies Policy